CCNA Service Provider Practice Test Results

Question 1
42% answer correctly
On Cisco IOS XR, for which purpose is the turboboot procedure used?
To boot the router into ROM Monitor mode
To install and boot up a PIE
The range for MTU values is 64 bytes to 1518 bytes on the interface.
Use the negotiation auto command in interface configuration mode to enable link auto-negotiation to ensure that devices that share a link segment are automatically configured with the highest performance.
Which of the following about 10/40/100 GigabitEthernet interface configuration on Cisco IOS XR is true?
To install the IOS XR software from scratch using the ROM Monitor mode
To perform an ISSU
The configuration supports only full-duplex operation.
The interface has no flow control configuration.
To speed up the time it takes to boot up the IOS XR router
To install and boot up a SMU
Question 2
39% answer correctly
Which statement about 10/40/100 GigabitEthernet interface configuration on Cisco IOS XR is true?
The range for MTU values is 64 bytes to 1518 bytes on the interface.
The configuration supports only full-duplex operation.
Use the negotiation auto command in interface configuration mode to enable link auto-negotiation to ensure that devices that share a link segment are automatically configured with the highest performance.
The interface has no flow control configuration.
Question 3
61% answer correctly
Which Cisco IOS XR command displays information about statically configured routes and their corresponding interface or next-hop?
show route ospf
show route static
show interfaces Loopback
show route connected
show ipv4 interfaces brief