CCNA Service Provider Practice Test Results

Question 1
70% answer correctly
Which Cisco IOS XR command presents a list of all interfaces, their Layer 3 address (if configured), and the status of the interface and protocol?
RP/0/RSP0/CPU0:PE1(admin)# show hw-module fpd location all
RP/0/RSP0/CPU0:PE1# show ipv4 interfaces brief
RP/0/RSP0/CPU0:PE1(config)# show bundle
RP/0/RSP0/CPU0:PE1(admin)# show platform
RP/0/RSP0/CPU0:PE1# show interface GigabitEthernet 0/0/0/1
RP/0/RSP0/CPU0:PE1# show controllers
Question 2
54% answer correctly
Which Cisco IOS XR command displays traffic counters for an individual interface that is configured on the router?
RP/0/RSP0/CPU0:PE1(admin)# show hw-module fpd location all
RP/0/RSP0/CPU0:PE1# show interfaces GigabitEthernet 0/0/0/1
RP/0/RSP0/CPU0:PE1# show interfaces brief
RP/0/RSP0/CPU0:PE1(config)# show bundle
RP/0/RSP0/CPU0:PE1(admin)# show platform
RP/0/RSP0/CPU0:PE1# show controllers GigabitEthernet 0/0/0/1
Question 3
39% answer correctly
Which statement about 10/40/100 GigabitEthernet interface configuration on Cisco IOS XR is true?
The configuration supports only full-duplex operation.
The range for MTU values is 64 bytes to 1518 bytes on the interface.
Use the negotiation auto command in interface configuration mode to enable link auto-negotiation to ensure that devices that share a link segment are automatically configured with the highest performance.
The interface has no flow control configuration.