CCNA Service Provider Practice Test Results

Question 1
46% answer correctly
Which option is enabled by default on Cisco IOS and IOS XE routers?
SSH server
AAA console login authentication
HTTP server
SSH and HTTP server
IPv4 unicast routing
IPv6 unicast routing
IPv6 and IPv4 unicast routing
Question 2
42% answer correctly
On Cisco IOS XR, for which purpose is the turboboot procedure used?
Use the negotiation auto command in interface configuration mode to enable link auto-negotiation to ensure that devices that share a link segment are automatically configured with the highest performance.
To install the IOS XR software from scratch using the ROM Monitor mode
The configuration supports only full-duplex operation.
To perform an ISSU
The range for MTU values is 64 bytes to 1518 bytes on the interface.
To install and boot up a SMU
Which of the following about 10/40/100 GigabitEthernet interface configuration on Cisco IOS XR is true?
To install and boot up a PIE
The interface has no flow control configuration.
To boot the router into ROM Monitor mode
To speed up the time it takes to boot up the IOS XR router
Question 3
43% answer correctly
Which Cisco IOS XR command is involved in enabling remote access?
RP/0/RSP0/CPU0:PE1(config)# username CISCO password LAZ
RP/0/RSP0/CPU0:PE1(config)# router static
RP/0/RSP0/CPU0:PE1(config)# vrf default
RP/0/RSP0/CPU0:PE1(config)# line console 0
RP/0/RSP0/CPU0:PE1(config)# telnet ipv4 server max-servers 20