CCNA Service Provider Practice Test Results

Question 1
70% answer correctly
Which Cisco IOS XR command presents a list of all interfaces, their Layer 3 address (if configured), and the status of the interface and protocol?
RP/0/RSP0/CPU0:PE1# show ipv4 interfaces brief
RP/0/RSP0/CPU0:PE1# show controllers
RP/0/RSP0/CPU0:PE1# show interface GigabitEthernet 0/0/0/1
RP/0/RSP0/CPU0:PE1(admin)# show hw-module fpd location all
RP/0/RSP0/CPU0:PE1(config)# show bundle
RP/0/RSP0/CPU0:PE1(admin)# show platform
Question 2
54% answer correctly
Which Cisco IOS XR command displays traffic counters for an individual interface that is configured on the router?
RP/0/RSP0/CPU0:PE1# show interfaces brief
RP/0/RSP0/CPU0:PE1(admin)# show platform
RP/0/RSP0/CPU0:PE1(config)# show bundle
RP/0/RSP0/CPU0:PE1# show controllers GigabitEthernet 0/0/0/1
RP/0/RSP0/CPU0:PE1(admin)# show hw-module fpd location all
RP/0/RSP0/CPU0:PE1# show interfaces GigabitEthernet 0/0/0/1
Question 3
42% answer correctly
On Cisco IOS XR, for which purpose is the turboboot procedure used?
To install and boot up a SMU
To install the IOS XR software from scratch using the ROM Monitor mode
To boot the router into ROM Monitor mode
The configuration supports only full-duplex operation.
The range for MTU values is 64 bytes to 1518 bytes on the interface.
To perform an ISSU
The interface has no flow control configuration.
To install and boot up a PIE
Use the negotiation auto command in interface configuration mode to enable link auto-negotiation to ensure that devices that share a link segment are automatically configured with the highest performance.
Which of the following about 10/40/100 GigabitEthernet interface configuration on Cisco IOS XR is true?
To speed up the time it takes to boot up the IOS XR router