CCNA Service Provider Practice Test Results

Question 1
42% answer correctly
On Cisco IOS XR, for which purpose is the turboboot procedure used?
To boot the router into ROM Monitor mode
The range for MTU values is 64 bytes to 1518 bytes on the interface.
To install and boot up a PIE
To perform an ISSU
The interface has no flow control configuration.
To install the IOS XR software from scratch using the ROM Monitor mode
To speed up the time it takes to boot up the IOS XR router
Use the negotiation auto command in interface configuration mode to enable link auto-negotiation to ensure that devices that share a link segment are automatically configured with the highest performance.
Which of the following about 10/40/100 GigabitEthernet interface configuration on Cisco IOS XR is true?
To install and boot up a SMU
The configuration supports only full-duplex operation.
Question 2
39% answer correctly
Which statement about 10/40/100 GigabitEthernet interface configuration on Cisco IOS XR is true?
Use the negotiation auto command in interface configuration mode to enable link auto-negotiation to ensure that devices that share a link segment are automatically configured with the highest performance.
The interface has no flow control configuration.
The range for MTU values is 64 bytes to 1518 bytes on the interface.
The configuration supports only full-duplex operation.
Question 3
63% answer correctly
What does a transparent LAN switch use to build its CAM table?
STP messages exchanged with neighbor bridges
Analysis of the source MAC address of incoming frames on the bridge ports
Dynamic routing protocol updates from neighbor bridges
BPDU messages exchanged with neighbor bridges