CCNA Service Provider Practice Test Results

Question 1
46% answer correctly
Which option is enabled by default on Cisco IOS and IOS XE routers?
SSH server
HTTP server
IPv6 unicast routing
IPv6 and IPv4 unicast routing
SSH and HTTP server
AAA console login authentication
IPv4 unicast routing
Question 2
42% answer correctly
On Cisco IOS XR, for which purpose is the turboboot procedure used?
To perform an ISSU
To speed up the time it takes to boot up the IOS XR router
The configuration supports only full-duplex operation.
To boot the router into ROM Monitor mode
The interface has no flow control configuration.
The range for MTU values is 64 bytes to 1518 bytes on the interface.
To install and boot up a SMU
To install and boot up a PIE
To install the IOS XR software from scratch using the ROM Monitor mode
Which of the following about 10/40/100 GigabitEthernet interface configuration on Cisco IOS XR is true?
Use the negotiation auto command in interface configuration mode to enable link auto-negotiation to ensure that devices that share a link segment are automatically configured with the highest performance.
Question 3
43% answer correctly
Which Cisco IOS XR command is involved in enabling remote access?
RP/0/RSP0/CPU0:PE1(config)# vrf default
RP/0/RSP0/CPU0:PE1(config)# username CISCO password LAZ
RP/0/RSP0/CPU0:PE1(config)# router static
RP/0/RSP0/CPU0:PE1(config)# telnet ipv4 server max-servers 20
RP/0/RSP0/CPU0:PE1(config)# line console 0