CCNA Service Provider Practice Test Results

Question 1
42% answer correctly
On Cisco IOS XR, for which purpose is the turboboot procedure used?
The configuration supports only full-duplex operation.
The interface has no flow control configuration.
Use the negotiation auto command in interface configuration mode to enable link auto-negotiation to ensure that devices that share a link segment are automatically configured with the highest performance.
To install and boot up a PIE
To install and boot up a SMU
To speed up the time it takes to boot up the IOS XR router
To install the IOS XR software from scratch using the ROM Monitor mode
To perform an ISSU
The range for MTU values is 64 bytes to 1518 bytes on the interface.
To boot the router into ROM Monitor mode
Which of the following about 10/40/100 GigabitEthernet interface configuration on Cisco IOS XR is true?
Question 2
39% answer correctly
Which statement about 10/40/100 GigabitEthernet interface configuration on Cisco IOS XR is true?
The configuration supports only full-duplex operation.
Use the negotiation auto command in interface configuration mode to enable link auto-negotiation to ensure that devices that share a link segment are automatically configured with the highest performance.
The range for MTU values is 64 bytes to 1518 bytes on the interface.
The interface has no flow control configuration.
Question 3
42% answer correctly
Given the CIDR address range of 200.165.160.0 to 200.165.191.255, what is the CIDR block?
200.165.160.0/18
200.165.160.0/19
200.165.160.0/20
200.165.160.0/17
200.165.160.0/21